Small induction heater is super mini and lightweight-Kehua
by:Kehua2022-08-01
Kehua small induction heating equipment heating device is also called high-frequency equipment. It is a variable-rate equipment that uses the principle of electronic tube oscillation to convert the power frequency to a frequency of 100--500 kHz or higher. my country has been able to produce a series of 10-200 kilowatts. The frequency of the power source is lower, and the surface hardening layer is more bath; the power is low, the frequency is higher, and the surface hardening layer is also a saddle wave. In order to realize quenching along the contour of the middle modulus gears, sprockets, shaft silo, etc., the Mechanical Research Institute successfully developed the so-called ultrasonic induction heating equipment through fire salt test research to fill the gap of this frequency. Lihua Machinery Small Induction Heating Equipment Factory adopts increasing or decreasing capacitance. The high frequency is improved, the frequency range is from 2.0 to 300 kHz, and the depth of the hardened layer can be changed from a few tenths of a millimeter to 2 millimeters, which makes the selection of the current frequency more reasonable. my country has been able to produce a series of 10-200 kilowatts. The frequency of the power source is lower, and the surface hardening layer is more bath; the power is low, the frequency is higher, and the surface hardening layer is also a saddle wave. In order to realize quenching along the contour of the middle modulus gears, sprockets, shaft silo, etc., the Mechanical Research Institute successfully developed the so-called ultrasonic induction heating equipment through fire salt test research to fill the gap of this frequency. Kehua Small Induction Heating Equipment Factory adopts increasing and decreasing capacitors. The high frequency is improved, the frequency range is from 2.0 to 300 kHz, and the depth of the hardened layer can be changed from a few tenths of a millimeter to 2 millimeters, which makes the selection of the current frequency more reasonable. Small Induction Heater Product Details Heater Product Name: Handheld Mini High Frequency Heating Rusty Screw Remover Model: Belink-1000W Product Introduction: Handheld Mini High Frequency Heating Rusty Screw Remover Belink-1000W applies magnetic induction Technology, can heat treatment of small parts of automobiles, machinery and various metal parts and polyethylene, mainly used to heat various automobile rusted bolts, nuts, gears, pulleys, pulleys, bearings, sensors and so on. There is no open flame, and there is no need to avoid various flammable substances such as plastics; no water cooling is required, the operation is safe, the use is simple, and it is convenient to carry. This machine is a 1000W hand-held inverter power supply. It is mainly used to heat the threaded nut to loosen it. It can also be used for heat treatment of gears, pulleys, pulleys, bearings and other precision parts and plastic parts. Various sizes of screws can be heated to 800 degrees in 5-40 seconds. Technical parameters: Working conditions: 1. Voltage: 220V 2. Rated current: 4. 3. Output current: 150A 4. Operating frequency: 50~60 Hz 5. Power: 1000W 6. Heating temperature: 800 ℃ 7. Heating to 800 ℃ time required: 5-40 seconds 8. Instrument protection temperature: 80 ℃ Use environment range: 1. Ambient temperature -40 ℃ ~ 60 ℃ 2. Relative humidity small induction heater Above is a small induction heater - handheld mini The product introduction of the high-frequency heating rusty screw remover is really easy to operate, mini and compact, designed by Kehua.